Bill Jensen Hieronymus analyzer plans

A place to discuss all aspects of radionics.
Posts: 4
Joined: Tue Jun 05, 2018 4:00 pm

Bill Jensen Hieronymus analyzer plans

Postby erik » Tue Jun 05, 2018 8:27 pm

Hi everyone.
I’m trying to assemble a machine according to the plans made available by billjensen.
What I’m having a hard time to understand is the connection of the well to the circuit. I’m not talking about the two wires coming out of the enamel copper wire, but about the other connection. Any help?

User avatar
Posts: 168
Joined: Thu Jul 18, 2013 4:36 am

Re: Bill Jensen Hieronymus analyzer plans

Postby realityphantom » Thu Jul 26, 2018 12:00 am

For me when it comes to wiring a witness well I go for metallic wells that are insulated from the case. Even if the case is wood or plastic. Forgive not having an example picture. One of my last devices I used two dipping cups made of stainless steel. In the bottom of each cup I drilled a single hole in each one and used a small carriage bolt (has a rounded flush end in the bottom, using a nut on the underside of the cup to secure the bolt and a wire attached to it.

Posts: 4
Joined: Thu Sep 28, 2017 4:02 pm

Re: Bill Jensen Hieronymus analyzer plans

Postby BBS » Mon Sep 03, 2018 4:05 pm

Sorry for my previous post but i don't remember what i've wrote!

Return to “Radionics”

Who is online

Users browsing this forum: No registered users and 1 guest