The Vril Engine

The Vril Engine was developed on the back of the orgone stack project. There are several areas, which need further experimentation, such as types of eloptic conductor, and orgone insulator. We believe, that in order to gain the best form of eloptic output from the Vril Engine an organic insulator should be used. On top of this we need to discover if the separation distance of the eloptic conductor, plays a major part in determining the Vril energy output. If as suspected, it is, then a closer spacing with minimal thickness insulation would yield stronger results.

The Vril Engine uses the orgone stack technology, and regular orgone matrix tech. The orgone stack directs the eloptic energy towards the Vril Engine output device, which is then pulsed with a set square wave frequency of 7.83Hz. The solenoid is wound from the bottom of the Vril output module to the top. The frequency is then injected from the bottom of the winding, before returning at the top. This is done so that the h-field is driving the eloptic energy along its path towards the operator.

The coil is not currently present in the photographs, but that is the next phase of construction.

Two coupling electrodes are used within each orgone stack. This is purely experimental and is based on a German patent (DE19915730) The applied electric field, enhances the E-field in the eloptic insulator, in the example of these orgone stacks, the insulator is comprised of solid birch wood, still utilising the organic principals of Reich. An eloptic conductor component is made up of Zinc coated steel. The steel allows for the magnetic h-field to create a more pronounced flux, in comparison to non ferrous materials.

A high voltage input is preferable, but has not yet been tested. Even a small DC power supply will slightly alter the electron alignment in the orgone insulator material. Since there is no large scale current drain, the DC source can be supplied by batteries for a long period of time.

The combination of the E-fields, and the h-fields at 90º to one and other create a G-field, See [Aspden No.3. (2005)] for the theory of electrostatic gravity.

As an experimental process we are looking at the effects of light absorption in determining the best form of eloptic reflector to make up the conductor of the Vril Engine’s orgone stacks. It seems logical to make one side of the eloptic conductor, rough and absorbing, while the other side of the eloptic conductor should be polished and reflective.

Overall, it may turn out that an entirely transparent orgone stack may prove to be the most conducive form of eloptic capacitor for the Vril Engine. The trick is finding an affordable, transparent, and conducting solid material.

The Vril Engine is still very much a long running research project, but is due to be mounted into the core of a new psionic device. Over time, we may be successful in determining the most appropriate materials, and assembly for the orgone stacks, and possibly future versions of the Vril Engine.

 

Related Blogs

  • Related Blogs on orgone stacks

Experimental Output Module

Here is a design I had lying around on my computer. The ultimate goal of the module was to have it cast into a resin block about 2ft tall, with a large clear quartz crystal embedded into it. The laser is used experimentally to allow for light transfer of a radionics signal, it could also be used to pulse audio frequency into the heart of the quartz. The orgone capacitor is used to collapse the gravity field around the regular orgone matrix. While it is a crude version, the orgone capacitor is far more superior to the orgone matrix material. The capacitor needs a lot of work, and it is something which I have begun to look at under the project title of Orgone Stacks. No working version of this experimental module has ever been put together, but it is something I would like to try, if time and resources allowed.

Related Blogs

  • Related Blogs on orgone stacks

Scalar Coil Experiment

I have always had a great deal of success with the toroidal style Scalar coils, such as the like developed by Jon Logan. These fascinating coils emit an energy that has become termed scalar. In popular physics these are linked to zero spin particles such as the Boson. Theoretically, it is possible to create a scalar field by opposing two identical waves which are out of phase with one another. The black projects community term scalar generators as split phase coils. This was something, which eluded both myself, and my physics tutor, who coincidently had done her Phd on Scalar waves. Time has a strange way of combining all the pieces of the puzzle.

The coils such as the ones developed by Logan, work on the principle that a small scalar field is made when the two identical waves create a magnetic null point at the node where they become out of sync. The genius of using quadrifilar wire allows for a greater degree of nodes to be combined in one small package. One thing which I found uncanny about the quadrifilar wire that Logan uses, is its link to the Chi Knot pattern, A design which was widely used by the Celtic tribes, and Saxons in their artwork.

While impressed with the ability of the regular toroidal scalar coils, I had a niggling idea in the back of my head which I needed to experiment with. It was after reading through several physics papers, and uncovering the Russian research into torsion fields, also termed spin fields, that I came up with an idea based on entropy. I still don’t fully understand how the two are linked to my idea, but I just like to let the imagination run wild. I will briefly highlight the theory behind torsion fields.

Positive Entropy, i.e. (Evaporation of Accetone)= SR (Right Handed Torsion: Time Emission)

Negative Entropy, i.e. (Freezing of Water)= SL (Left Handed Torsion: Time Absorption)

The SR is the repulsive force, and SL is the attractive force, together they create torsion.

The idea of the two opposing forces led me to use two opposing electron flows in conjunction with the regular toroid setup. To do this, I had to wind the coil slightly different to the way Logan teaches. Instead of using one single strand of wire, I had to use two in parallel. Two 60′ lengths, gets quite difficult to manage, let me tell you!

I persisted, and taped the two lengths together at each end, folded them over, as per Logan’s method and begun to wind them. Once the coil was complete, after some considerable time, I was able to implement the theory.

The positive from one oscillator is crossed over with the negative of another. They are as accurate as can be achieved with analogue electronics, but there may be some drift. I managed to get the scopes to read equal 15Hz for each timer, but there is always a small intolerance.

The positive flow and negative flow run parallel to each other within the coil. With positive and negative flows cancelling at the nodes with the applied frequency. It may be that the parallel flow of electrons in opposite directions also has a small scalar effect, giving a performance boost to the coil.

Using a gauss meter on a traditional coil of the same Ohmic value as a base reading. I then set forth and measured the reading of the new coil. The gauss had dropped considerably, leading me to believe that a greater degree of electromotive force had become scalar, rather than magnetic. The experiment seems to have been a success. However, it will require further testing.

Edit:

One thing I would like to alter is the oscillator and amp circuit. The oscillator on its own does not output enough power for the scalar coils. In fact, the majority of the voltage is lost. By adding the power amp, the output is increased considerably. I aim to replace the power amp IC with a power transistor and configure the coil so that the reverse voltage is put back into the circuit rather than lost. This would require some testing, but it is something I have started to work on.

Related Blogs

Bio-shield

My bio-shield was inspired by a sacred geometry protection seal which was designed by the Sevranx brothers. I first came across this design on Chris Gozdzik’s site “divining mind”

I feel that although the symbolic design would work, it needed to be enhanced to make it even more powerful. It has only become possible quite recently to do what I wanted with the shield, with a little help from Joseph Max of Aetheric Arts, I was able to emulate the loop antennas of early radio. This shield also became a proof of concept, which allowed me to try out the winding method so that it could be used in a field radionics device which is in the pipeline.

The design and construction of the shield employs early stealth technology in a proprietary manner, the component of which I have had sitting on a shelf for years and only decided to use fairly recently. The aim is to match the bio-electrical signature of the witness and pass an equal opposing signal around it, this would have a scalar effect cancelling out the biological signal rendering the target invisible to all that would wish them harm.

The tech for such shielding exists on warships, but is employed only to make the ship magnetically inert.

Royal Rife

Royal Rife cured cancer. Yes you read that correctly, Royal Raymond Rife cured, among many other diseases, cancer. You may be asking, “if this is true, then why have I not heard of it? Why are doctors not using Rife’ technology?” The simple truth is Doctors had heard of Royal Rife’s work in the 1930’s, they even billed his breakthrough as “the end to all disease”. Clinical trials were carried out on sixteen terminally Ill cancer patients. The team conducting the research was made up of respected doctors and pathologists, whose aim was to assess the patients over 90 days of treatment.

To everyone’s amazement fourteen of the sixteen patients were found to have been completely cured of a seemingly incurable disease. The remaining two patients were cured after a further month of treatment.

Royal Rife through his work as a highly skilled engineer had developed a device which was able to oscillate bacteria, fungus, and disease cells at their resonant frequency. The result being that the cell membranes ruptured destroying the diseased cells. This machine was to later be dubbed, the Rife machine.

A large number of medical professionals who originally supported Rife’s work, begun to deny all links with him after a few years. A few met a sticky end, labs were destroyed by arson, and research papers were spirited away. Dr Rife himself was killed by an “accidental” overdose of valium in 1971.

It is clear from these past accounts that a monster was at play. This monster took the guise of the American Medical Association. After a failed attempt to buy Rife’s technology, the carnage mentioned previously mysteriously unfolded. You need to understand that far from having your health as their vested interest, organizations such as the AMA are more concerned with keeping you sick so that they can sell you more drugs, the sale of which lines their pockets. I must mention with clarity that the lie is different at every level,. Your doctor will believe what they have been taught, and will have your best interests at heart. The lie, goes far deeper, down the corporate rabbit hole. It’s just business as they would say.

While a Rife machine is a miraculous instrument, through my technical understanding, I can see how a negative action could be created from engineering the machine to work in a different manner. If the Rife machine can destroy all manner of disease cells, parasites, viruses, in essence, organisms. It can kill any organism, even healthy ones if the operator wanted it to.

You may believe that this is why the medical profession has essentially denied all knowledge of it, because it is dangerous? Not exactly.

To cure cancer currently a patients best hope is to undergo radiation therapy, while yes, radiation therapy will destroy the cancer cells, it is not very discriminate. It will continue to destroy the beneficial cells in your body, including the lymphocytes (white blood cells) the very thing your body uses to fight infection.

While the intention may be positive, radiation therapy does more harm than good. What should be used is a different form of radiation, electromagnetic radiation. It is this radiation which the rife machine employs in the form of radio frequencies. The radio frequencies can be tuned to a greater extent, far more than techniques used in current radiation therapy.

Still after nearly 80 years, the technology that Rife developed remains lost to the vast majority of the world. It is only just starting to be rediscovered by a few daring alternative therapy practitioners, mainly in Europe where the law allows much more freedom in comparison to America. Hopefully, in time, when people become much more accepting and learnt to think outside the square thing, an end to all disease can once again become a reality. Until this golden time is upon us the Medical Mafia keeps pushing us drugs and Royal Rife’s work is but a memory. It is up to us to create a positive future, let’s start now.

I have selected a few videos for you related to Dr Rifes work. The first video shows the effect of Rife frequencies on bacteria. The second is an audio interview with Royal Rife recorded in the 50’s. I hope you enjoy.

Related Blogs